Karcher WD2 and WD3 fleece filter bags
If your machine is one of the models below, the bag you need is the Karcher WD2/WD3 fleece filter bag.
Karcher WD2 and WD3 wet and dry vacuum ranges.
Specification
| Reference | Karcher WD2/WD3 fleece filter bag |
|---|---|
| Fits | Karcher WD2 and WD3 wet and dry vacuum ranges |
| Capacity | Matched to the WD2/WD3 tank size (typically 12 to 17 litres tank, bag sized accordingly) |
| Material | Non-woven fleece |
| Bags per box | 5 bags (standard retail pack) |
What to check before you order
Wet and dry vacuums use a fleece filter bag, not a paper dust bag, because the bag also has to cope with damp debris during dry-mode use. Never fit a paper household vacuum bag to a WD machine.
How to replace it
- Unplug the vacuum and open the tank lid.
- Lift out the full fleece filter bag by its card or plastic collar, keeping it level so it does not spill.
- Check the collar shape against the Karcher WD2/WD3 fleece filter bag before fitting the new one; a bag that does not sit flush will not seal.
- Slide the new fleece filter bag collar into the machine's bag holder until it clicks or seats fully home.
- Close the compartment door. Most machines will not run, or will run with reduced suction, if the door is not fully latched.
- Run the vacuum briefly on an empty patch of floor to confirm suction feels normal before doing a full clean.
Common mistakes
- Buying by vacuum model number alone instead of checking the bag shape, which leads to a bag that does not seal.
- Reusing a bag past the fill line printed on it, which chokes airflow and can strain the motor.
- Forcing a bag from a different reference into the holder; if it does not seat without pressure, it is the wrong one.
How this reference sits in the Karcher range
Karcher also uses the Karcher fleece filter bag, part number 2.863-006.0 shape, and the two are not interchangeable. Compare before you order:
| Other Karcher reference | Fits | Capacity |
|---|---|---|
| Karcher fleece filter bag, part number 2.863-006.0 | Karcher WD4, WD5, WD5 P and WD6 PS wet and dry vacuum ranges | Matched to the WD4 to WD6 tank size (typically 20 to 30 litres tank, bag sized accordingly) |
How long a pack lasts
A retail pack holds 5 fleece filter bags. At the usual rhythm of one change every four to eight weeks in an average household, that pack covers roughly 5 to 10 months, so most people buy bags once or twice a year rather than monthly.
The 17 litre capacity is the volume the bag holds, not a fitting measurement: two bags of the same capacity can have completely different collars. Use it to judge how often you will be changing the bag, and the collar shape to judge whether it fits. Our guide on how often to change a vacuum bag explains what shortens that interval.
Where this information comes from
The specification above is taken from Karcher official accessories documentation (karcher.com). References are re-checked when a manufacturer renumbers a pack; if you find a discrepancy with your own machine, tell us and the page is corrected.
Tools, workspace, and measurements to prepare before fitting
Work on a dry floor with enough space to lay the vacuum tank on its side without pulling the hose. A clear area of about 1 metre by 1 metre is enough for the machine, the new bag, and the waste bag.
- Use disposable gloves if the old bag contains plaster dust, ash, sawdust, or pet hair.
- Keep a 50 litre bin liner open beside the vacuum so the full bag can be lowered straight into it.
- Use a torch to check the bag holder, the inside wall of the tank, and the filter area before closing the machine.
- Use a ruler or tape measure only to compare the old collar with the new collar. Do not choose the bag by width or capacity alone.
- Keep a damp cloth ready for the sealing face around the holder. Wipe it, then wait 2 to 3 minutes for it to dry before fitting the new bag.
Do not cut, fold, or trim the collar to make it fit. A collar that is out by only 2 or 3 mm can leave a leak path. That leak path sends fine dust into the tank instead of into the bag, and the pleated filter then blocks much faster.
Detailed fitting checks that prevent dust bypass
Before the new bag is pushed home, check the holder for two common faults: dust packed behind the guide rails, and a bent locating edge. Either fault can make the collar look fitted when it is actually sitting proud.
Hold the collar flat against the holder and press evenly with two thumbs. Do not press on the fleece body of the bag, because this can tear the seam near the collar. Once fitted, run a finger around the collar edge. The gap between the collar and the holder should be even all the way round, with no corner lifted.
After closing the machine, run it for 10 to 15 seconds with the hose inlet open. Then switch off and listen as the motor stops. A loose collar often gives a brief fluttering or whistling sound. If you hear this, open the tank and reseat the bag before using the vacuum on fine dust.
| Check point | Figure to use | What to do if it fails |
|---|---|---|
| Collar sits flat | No visible lifted corner, gap under 1 mm | Remove the bag and clean the holder rails |
| Drying time after wiping | 2 to 3 minutes | Wait longer, then refit on a dry surface |
| Short suction test | 10 to 15 seconds | Stop and inspect if there is fluttering or dust smell |
| Tank inspection after dusty work | Less than a light dusting outside the bag | Check the collar seal and main filter before continuing |
Frequent mistakes and how to recover from them
If the vacuum has been used with a poorly seated bag, do not just fit another bag and continue. Empty loose debris from the tank first, then clean the filter area. Fine dust left in the tank can be pulled into the filter as soon as the motor starts.
If the fleece bag has been exposed to liquid, remove it before it becomes heavy enough to pull on the collar. A damp bag can sag, and the seal can open at the top edge. Let the tank air dry for at least 30 minutes with the lid off before fitting a fresh dry bag.
If suction falls sharply after a few minutes of use, check the hose and floor tool before blaming the bag. A coin, screw, wood chip, or clump of fibres can lodge in the hose bend. Disconnect the hose and look through it toward a light source. If you cannot see light, clear the blockage from the tool end rather than forcing it deeper.
If you have ordered the larger Karcher fleece type by mistake, do not try to adapt it. Compare the range before reordering, especially if there are several Karcher machines in the same garage or workshop. The larger type is covered separately at Karcher WD4 to WD6 bags.
Special cases: plaster, ash, damp debris, and mixed workshops
Plaster dust and sanding dust load a fleece bag quickly because the particles are very fine. For this work, use shorter cleaning sessions of 5 to 10 minutes, then stop and check suction. If the motor note rises and airflow drops, change the bag even if it does not look full.
Cold ash must be treated as fine dust. Do not vacuum warm ash. Even when ash looks dead, leave it for at least 24 hours after a fire, then check that there is no heat in the material before vacuuming. A bag used for ash should be discarded after the job, because ash holds odour and blocks airflow.
For damp grit, mud, or water pickup, check the machine instructions for the correct wet use setup. A fleece dust bag is for dry collection and damp dry debris, not for holding liquid as a container. After wet work, dry the tank, hose, and filter area before returning to bagged dry use.
In shared spaces, mark the box or storage shelf with the vacuum range rather than only the word Karcher. This prevents WD2 and WD3 bags being mixed with larger range bags. For other Karcher bag pages, use the brand index at Karcher vacuum bags, and for general bag change questions use the vacuum bag FAQ.
Read next
- Electrolux and AEG GR200S dust bags: The exact bag reference for Newer Electrolux and AEG cylinder ranges that moved away from the classic s-bag opening to a wider inlet.
- Hoover vacuum bags: Which bag reference fits your Hoover vacuum cleaner, model by model, with sourced specifications.
- Hoover H30 dust bags: The exact bag reference for Hoover Freespace and Telios Extra cylinder vacuum ranges.
